STANDARD SIZES for Swan Brand TUFNOL

Despatch is normally ex-stock for items shown in BOLD.  Other items may require to be made to order.  Sizes not listed may be available, subject to special order.

ROUND RODS

Diameter	Nominal Length	Type
mm	mm
6	1200	Machined from sheet
8	1200	Machined from sheet
10	1200	Machined from sheet
12	1200	Machined from sheet
12.7	1200	Rolled and moulded
16	1200	Rolled and moulded
19	1200	Rolled and moulded
20	1200	Rolled and moulded
22	1200	Rolled and moulded
25	1200	Rolled and moulded
25.4	1200	Rolled and moulded
30	1200	Rolled and moulded
32	1200	Rolled and moulded
35	1200	Rolled and moulded
38	1200	Rolled and moulded
38.1	1200	Rolled and moulded

Other sizes up to 38.1mm diameter can readily be made to order.

Standard lengths are 1200mm approximately

Rods under 12.7mm diameter are normally machined from sheet and have flat, in-plane laminations.  Rods 12.7 diameter and over are rolled and moulded individually.  Rolled and moulded rods under 12.7 diameter can be made to order.  Minimum production quantities may apply for certain items.

ROUND TUBES

Not available. See Kite Brand TUFNOL

OTHER SECTIONS

SQUARE and RECTANGULAR BAR

Rolled and moulded square and rectangular bar is made in sizes from 4.8 x 4.8 mm up to 38.1 x 88.9mm (3/16 x 3/16 inches up to 1.1/2 x 3.1/2 inches).  Refer to TUFNOL for details.

Standard lengths are 1200mm approximately.  Minimum production quantities may apply for certain items.

HEXAGONAL BAR

Hexagonal bar is rolled and moulded and the across flats dimensions are machined to suit Metric, Whitworth or other standard hexagon sizes.

Size range from 0.445 to 1.100 inches (11.3 to 28.0mm) across flats

Standard lengths are 1200mm approximately.  Minimum production quantities may apply for certain items.

SQUARE and RECTANGULAR TUBES

Not available. See Kite Brand TUFNOL

ANGLE SECTION

Not available. See Kite Brand TUFNOL

CHANNEL SECTION

Not available. See Kite Brand TUFNOL

Back to main Swan Brand TUFNOL page

Back to Home page

A full machining service is available from Tufnol Composites Ltd for this and many other engineering plastics and composites.

Tufnol Composites Ltd, Wellhead Lane, Perry Barr, Birmingham B42 2TB, United Kingdom.

Quality Registration BS EN ISO 9001:2000, BS EN 9100:2003 and AS 9100 Reg. No. FM 90942

The information given here is believed to be correct, but completeness and accuracy are not guaranteed. The user shall be fully responsible for determining the suitability of products for the intended use.   

© 2000 – 2005 Tufnol Composites Ltd.